

Bronze Aussie team have a special visitor drop in to check on the teams progress
We recently had a special visitor to the Bronze Aussie workshop with hot rod legend and the original builder of Bronze Aussie Rod Hadfield dropping in to lend a hand . Having the orginal builder of the car in the workshop has certainly given everyone a good motivation boost. Rod assited the team in working on fitting the rear doors , locks and seals. With the roof chop on the car there is quite a bit of fiddly work that needed to happen to make it fit correctly. We have also


Hydraulic Jack System
This rebuild of Bronze Aussie will have very special feature that the team working on the car will get to appreciate very much once it is on four wheel. The car will have its own hydraulic jack system built in. The team have done this to make working on the car much easier, faster and safer. One of the big challenges on the previous version of the car was that as the car is so low to the ground getting a regular jack was underneath it to lift it up was almost impossible. The


Bronze Aussie July 2021 Update
Winter has certainly hit hard down in Victoria and whilst the cold nights make working in the shed a lot less comfortable progress has been coming along nicely on the Bronze Aussie rebuild since our last update. We have a couple of photos below of the car as it looks at the moment. As you can see the engine has had its mock fitting , the custom intake has been made , front suspension componentry made along with a number of other areas of progress. Over the next few days we